Watch the list as it will change upon detection of a new device. Windows / Open Control Panel (you wanna have this open before starting the above procedure)2. Load update image and click Restore wait until rebootInstalling driver goes like this:1. Press Power & Volume+ to start tablet - will be recognized by Rockbatch tool (green button at connected devices)9. Start Rockbatchtool after correcting the config.ini file = see below8. Optional: Shutdown tablet (not necessary in my case, since I can see the device stays connected in Windows Device Manager)7. Hold Vol+ and Power and connect USB to computer. When computer detects new device, release buttons (this is typically after 3-4 secs - if you hold longer, you will get to recovery mode (android bot with open belly) and you don't need to be there = use volume to bring up menu, use volume again to select 'reboot' and power button to confirm). Basically, the flash methods described are correct:1. You wanna read through the entire post to get all of it.Although the flash instructions are clear, timing remains an issue and since the tablet remains dark, you really don't know if you're doing it right. Finally, I managed to do so, by messing with the config.ini fiile of Rockbatch Tool. Hi all,yesterday I spent hours and hours trying to get my new Cube flashed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |